How do i install an electric operator on a canopy up and over door



The answer to your selected question is shown below.

A:

Electric operators from Hormann, Garador, SEIP and Carteck can all be fitted to most canopy up and over doors using a bow arm converter. The video below shows a Hormann canopy operator being fitted to an existing Hormann canopy door. The same basic steps apply to the other brands.

 

Before you start

  • Check the door opens and closes smoothly and stays balanced when you lift it halfway. An operator won't fix a door that's heavy or out of balance
  • Check the door panel is strong enough to take the bow arm, with solid fixing points
  • Make sure there's enough headroom and a solid ceiling fixing for the operator boom
  • Have a power socket near the operator's position

The main steps

  1. Fix the operator's header bracket above the opening, centred on the door
  2. Fit the bow arm to the back of the door panel
  3. Connect the operator boom to the bow arm slider, and hang the motor end from the ceiling
  4. Remove or disable the manual locking on the door
  5. Set the open and closed positions and the force settings, then test the safety reversal

Which doors are suitable?

Hormann and later Garador canopy doors use the same mechanism, so they're the easiest to convert. Most other single width canopy doors in good condition can also take a bow arm, but some older or lightweight doors flex too much. If you're not sure, send us a photo of the inside of your door and we'll check it before you order.

Always follow the manufacturer's instructions for your operator. See our guide to electric operators for up and over doors, or call us on 01926 463888.

Back to Faqs

We use cookies to provide you with a better website experience. Close this popup to carry on browsing, or click here to find out more about cookies