What are the ordering sizes for seceuroglide roller doors



The answer to your selected question is shown below.

A:

SeceuroGlide roller doors are made to measure and ordered using two sizes: the overall width and the guide height. How you work these out depends on where the door is being fitted.

Ordering sizes are exact

Your door will be made to exactly the sizes you order. No fitting tolerance is added, so if the door needs clearance to fit, take that off your sizes before you order. This matters most when the door is fitting between the opening, because brickwork is rarely perfectly square or level.

Overall width

This is the full width of the door, including both side guides. Guide widths vary between 60mm and 90mm depending on the model and door width, so check the guide size for the door you've chosen.

Guide height

This is the height from the floor to the top of the side guides. It doesn't include the roller box (end plates) that sits above. End plates on most door sizes are 300mm, but taller doors may need a larger size.

Fitting behind or in front of the opening

The door is fitted to the inside or outside face of the wall, so the guides sit either side of the opening and the roller box sits above it.

  • Width: Add one guide width to each side of your brick opening. Example: a 2250mm opening with 75mm guides is 2250 + 75 + 75 = 2400mm overall width
  • Height: Order the guide height to the height of the lintel. Example: a 2150mm lintel height means a 2150mm guide height. With 300mm end plates on top, you'll need at least 2450mm of clear height above the floor on that face of the wall

Fitting between the opening

The whole door, including the guides and roller box, fits inside the brick opening. Remember to take off your own fitting tolerance, because the ordering sizes don't include one.

  • Width: Measure the width at the top, middle and bottom, take the smallest measurement, then take off your tolerance
  • Height: Measure from the floor to the underside of the lintel on both sides, take the smallest measurement, then take off the end plate size and your tolerance. Example: a 2150mm opening height with 300mm end plates gives a guide height of around 1850mm, less your tolerance

* Fitting between the opening reduces the drive through height, because the roller box sits inside the opening. Where you have the space, fitting behind the opening keeps the full height and width.

Not sure about your sizes? Send us your measurements or call us on 01926 463888 and we'll check them for you. You can also read our DIY installation guide.

SeceuroGlide roller door critical dimensions for ordering

Back to Faqs

We use cookies to provide you with a better website experience. Close this popup to carry on browsing, or click here to find out more about cookies